Wethertex OT25 Wood-Flex Timber Paint Brilliant White

Wethertex OT25 Wood-Flex Timber Paint White

This premium quality protective coating not only protects from water, mould and mildew, but also offers an attractive satin finish. Optilife silicone technology provides water resistance and breathability, meaning mould and mildew don’t occur due to moisture trapped in the wood. Due to the high movement found in wood substrates, our OT25 Wood-Flex Satin Opaque Timber Paint is highly flexible, meaning it won’t crack as the building breathes.

Colours: White. Also available a wide range of colours. For other colour please see related products.
Application Tool: Brush, Roller or Spray
Suitable Substrates: All exterior timber substrates
Coverage: Approximately 14m2 / litre (Dependent on the nature and porosity
of the surface)
Application Temperature: 8˚C - 25˚C for a minimum of 24 hours

DESCRIPTION
Wethertex OT25 Wood-Flex Timber Paint is a quick drying, high quality opaque satin finish for all exterior timber. Developed using advanced Optilife silicone technology, OT25 is highly breathable and flexible and provides long term colour stability for your timber and total weather protection for up to 12 years.

PREPARATION
Ensure all surfaces to be painted are clean, dry and free from grease and loose or flaking material that may impair adhesion. Any faults in the substrate, particularly those that can lead to moisture penetration, must be rectified. If your substrate has been previously painted rub down with a fine waterproof abrasive paper and then rinse thoroughly. Bare substrates should also be abraded to allow improved adhesion. To improve inter-coat adhesion, repeat between all additional coats. Please avoid inhaling any sanding dust and always wear a face mask if fine sanding. Special precautions should be taken during preparation of pre-1960’s paint surfaces over wood and metal as they may contain harmful lead. All surfaces must be clean, dry and free from algae, lichen & other growths. On new or bare timber ensure pre-treated with a good quality suitable preservative. On resinous timbers it is recommended to use a suitable wood primer.

APPLICATION
Stir the product thoroughly. For the best results apply by brush, roller or spray. Application tool type and quality may influence the finished appearance. Apply liberally and avoid overspreading. Not to be applied below 8°C. Under normal conditions will be dry after 1-2 hours, add additional coats after 3-4 hours. Ensure good ventilation during drying and application. Do not apply externally when rain or other inclement weather is imminent, ensure substrate is dry. It is recommended to apply 2 coats, though more may be required dependant on the nature and porosity of the substrate.