Rustoleum Hard Hat Anti-Corrosion Primer Aerosol 500ml
Rustoleum Hard Hat Anti-Corrosion Primer Aerosol 500ml is the quick anti-rust protector. In Red Brown or Grey - choose colour above.
• Quick working rust preventive primer
• For bare steel or slightly rusted surfaces
• Penetrates the rusted surface
• To recoat: 10 minutes, to handle: 30 minutes
• Red for dark topcoats, grey for light topcoats
• Lead- and chromate free
• Coverage: 3-4 m² per aerosol
Technical Data
- Appearance: Flat
- Propellant: Dimethyl ether
- Recommended film thickness: 25 ìm dry, equals averagely 80 ìm wet
- VOC-content: 630 g/l
Drying times 20°C/50% r.v.
- To touch: 15 minutes
- To handle: 30 minutes
- To recoat: Within 1 hour or after 48 hours
- Full hardness 7 days
- Heat resistance: 100°C (dry heat)
COVERAGE
- Theoretical: 2.5 m² per spray can at 25 ìm dry
- Practical: Practical coverage depends on many factors such as porosity and roughness of the substrate and material losses during application.
SURFACE PREPARATION
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means. Prime or spot prime with the recommended RUST-OLEUM Primers. Sand intact coatings to provide a proper key for adhesion. The surface must be clean and dry during application.
DIRECTION FOR USE
Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard. Shake frequently during use. Hold can approx. 25 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags. Apply several thin layers at a few minutes interval to achieve adequate coating thickness. After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.
APPLICATION CONDITIONS
For good results the relative humidity shall be below 85% and the temperature of the can above and substrate 0°C.
REMARKS
Bright topcoats may need a light coloured primer/intermediate coat.
