PPG Sigma Steelguard 801 White 20L
PPG Sigma Steelguard 801 is a one component, thin film, intumescent coating which gives structural steelwork two hours of protection against cellulosic fires.
Steelguard 801 is solvent based but is quick drying, offers short handling times and is good for both off-site or on-site application.
It is suitable for C1 to C4 internal and external environments (ISO 12944). No topcoat is required for dry internal (C1) environments. Steelguard 801 is weather resistant for up to 12 months without a topcoat, provided the coating has been applied in accordance with information sheet 1222 and is not subject to running or pooling water, high humidity or immersion conditions.
Steelguard 801 comes in a white, matt finish.
Application (at 20C):
- Stir well before use
- Apply with airless spray (brush or roller for small areas only)
- Touch dry: 20 minutes
- Recoatable: 4 hours
- Full cure after 46 hours
- Coverage: 1.07m2 per litre at 700 microns
- Volume solids: 73%
- Recommended dry film thickness: 700-1000 microns per coat
- Recommended thinner: 21-06 (Amercoat 65). Normally no thinner required
Call us on 01753 686888 or email info@tools-paint.com for more information.
Data sheet and MSDS available on request.
