Typical dispatch 2-3 days on a 24hr service (excl. wknd’s). For expedited delivery please call us.


Technical Support Line 01753 684084

Manor QD Enamel

Hard-wearing, fast drying top-coat with a high-gloss finish
£30.17 (excl. VAT)
£36.20 (inc. VAT)

You can earn 36 loyalty points with this purchase

A half hour dry high gloss spray enamel for components or articles made from sheet or structural metals such as shelving, partitions, pumps, gates, railings wrought iron work, garden machinery and a host of OEM components. It is used wherever there is a need for general purpose finish to dry rapidly.

It may also be used 'direct to metal' without a primer for items that have no need for corrosion protection nor require a primer to fill surface imperfections and will only be used internally. Typical uses without a primer are small cast items and metal shelving.

Surfaces must be dry sound and free from dirt, dust and grease.
For spray application prime with Manor Fast Primer or similar and for brush application prime/undercoat with Manor Metal Primer or CV Primer Undercoat. Previously painted glossy surfaces should be lightly abraded prior to application to promote adhesion. Any non-ferrous metals must be pre-treated with Manor Wash Primer, Manor Chromate Free Wash Primer or Manor 1 Pack Etch Primer CT.

RAL, British Standard colours along with a vast library of colours can be produced in a gloss as standard.

Environmental conditions;
The air temperature should be at least 5C with a surface temperature 3C above the dew point and the relative humidity below 80% thus ensuring that the surface is dry and that condensation will not occur during application or drying.
Drying will slow significantly at temperatures below 10C.
Do not apply in conditions below 5C
Do not apply to external surfaces if the forecast is for rain to fall within the next 4 hours.
In exposed windy conditions a minimum air temperature of 8 C is recommended.

Airless Spray;
Ready for use but up to 5% thinners may be added to suit equipment. Typical tip size 11-13 thou or 0.28-0.33mm. Typical fluid pressure 140 kg/sq metre or 2000 p.s.i. Can be heated but to a maximum on 70oC
Conventional Spray; 
Up to 15% thinners may be added to suit equipment. May be hot sprayed at a maximum temperature of 70oC.
Not recommended, use Manor Fast Enamel

Over-coating / repainting;
If required a further coat of QD Enamel may be applied wet on wet.
QD Enamel is sensitive to re-coating after 6 hours. If re-coating after more than 6 hours but less than 21 days lightly abrade and re-coat with Manor Fast Enamel. If re-coating after more than 21 days lightly abrade and overcoat with Manor QD Enamel.

Product Code:
product review overlay image

Customer reviews

No reviews left yet
Write A Review

No reviews have been left for this product, be the first to leave a review
Widget Image