Hydron Nu-Guard AG Anti-Graffiti Coating Custom Mixed Colours

DESCRIPTION:
Nu-Guard AG Clear Coating is a specially formulated single pack external coating designed to give effective
protection against both fly-posting and graffiti. RAL Colours also available - please contact us for more details.

ADVANTAGES:
A one coat application where graffiti will not adhere to the surface, once dry, graffiti can be removed quick
and easy by using warm soapy water. No reapplication required. A single pack product which means there is no "Pot-life" associated with typical two pack or two component anti-graffiti coatings.

USES:
Most surfaces can be protected with just one coat of Nu-Guard AG Clear, giving quick application and
protection from Graffiti and fly posting.

Ideal for following applications: aluminium sliding, fibreglass, glass, masonry (includes brick, marble, stone, tile, granite and concrete), metal, street signs, stucco, utility boxes, vinyl siding, wood.

Finish: Clear Semi Matt

PACK SIZE:
Single component product, supplied in 5 litre cans.
VOLUME SOLIDS: 75%

COVERAGE RATE:
One coat @ 8 m² / Litre
WFT – 125 microns
DFT – 95 microns

DRYING TIME:
Touch Dry :………….1-2 Hours
Full Cure :……………....6 Hours

PREPARATION:
Ensure surfaces to be treated are clean, free from contamination and dry. To prevent concrete surfaces
darkening and application to very porous surfaces, it is advisable to apply one coat of Nu-Guard WB Concrete Sealer.

APPLICATION:
By brush/roller or spray. Apply in one heavy coat. Do not apply too thin. Should not be applied at temperatures below 5°C or when the relative humidity exceeds 85%.

GRAFFITI REMOVAL:
Graffiti should be removed using warm soapy water. If using a pressure washer, no more than 70bar should
be used.

EQUIPMENT CARE:
All equipment should be cleaned with white spirit.

STORAGE:
Store away from direct sunlight and sources of heat. Protect from frost. Do not allow moisture into the can.

SHELF LIFE:
12 months (in original sealed container).

HEALTH & SAFETY:
Refer to MSDS

Notes.
The coating will touch dry in one-two hours and full cure after six hours but will still appear to "Sticky". The surface has high level of friction (lack of slip) which gives the appearance of a typical paint that is not fully cured. This is a characteristic of the paint, when fully cured the friction could be mistaken for stickiness, it is not sticky, dust, dirt, contaminants and most importantly graffiti will not adhere to the coating.

Ensure that a thick/heavy coating is applied, failure to apply at high film thicknesses could mean that full properties are not achieved.