Most of the products offered are dispatched within 2-5 working days. Some products are not available because of the current situation. Call us for up-to-date information.


Free Delivery On Orders Over £150. Technical Support Line 01753 684084.

HMG PVC94 1K Vinyl Acrylic for Plastic and Cladding Custom Mixed Colours 5L

£90.54 (inc. VAT)
MPN: UB143/4.5

Your message can be up to a maximum of [option_max_length] characters.

You can earn 90 loyalty points with this purchase
FacebookYoutubeInstagramPinterestLinked In
A 1K vinyl acrylic with exceptional flexibility and adhesion. For direct application to plastic substrates and architectural cladding.

PVC94 is a coating for application to PVC, selected plastics and other 'difficult' substrates. Due to exceptional adhesion the use of a primer can usually be eliminated.

PVC94 is easy to use and can be applied by brush or spray to offer the applicator high quality redecoration and protection of the substrate. A wide variety of colours are available including metallics.

Due to its outstanding adhesion properties and flexibility usages include rigid PVC (Plastisol) cladding, PVC roofing, curtain sided trucks, interior and exterior automotive trim components, also over ABS and certain other difficult substrates, including abraded powder coatings. PVC is also commonly used on the reverse of glass kitchen splashbacks.

Please select the finish required from the menu above.

Click here to view all available colours and enter your colour reference in box provided. The colours represented digitally depend and vary according to your monitor/device settings and printer, so are for guidance only.

  • Solids: Approximately 30 to 40% dependent on colour
  • Flashpoint: -4ºC
  • Specific Gravity: 0.90 to 1.30 approximately dependent on colour
  • Viscosity: 75 - 85 seconds B4 Ford Cup
  • Colour retention: Excellent
  • Touch dry: 5-10 minutes
  • Firm dry: 30 minutes
  • Hard dry: 24 hours
  • Thinners: Thin2661 or ThinLC12standard or ThinLC12slow
  • Overcoating: 10 minutes minimum, maximum indefinite
  • Eqp. cleaning: HMG Gun cleaner
  • Film thickness: 100 microns WFT gives approximately 25 microns DFT
  • Coverage: 10 square metres per litre @ 25 microns dft
  • VOC: 0.720kg/L

By Brush: Thin if required with up to 30% of PVC brushing thinners. Apply PVC 94 LINE using a soft full brush with minimal laying off. Apply second coat with full brush - do not brush out otherwise this will re-dissolve first coat application.

By Spray: Thin to a spray viscosity of 20 40 seconds (dependent on equipment) with HMG PVC  94 LINE Thinners only. 3 grades are available Fast/Std/Slow dependent on area to sprayed.

Apply 2 light coats, allowing 5 - 15 minutes flash off between coats.

If colour bands are to be applied, allow PVC to air dry for 4 hours before masking using low tack tape and applying colour bands.
Avoid excessively high film thicknesses of PVC 94 LINE as flexibility will be impaired in thick films.
PVC blending clears are available for feathering out spot repairs on PVC Plastisol sheeting.
Not yet reviewed
Write an online review and share your thoughts with other shoppers!
Be the first to review this product.