Dulux Trade Blockfiller + 10 Litres
A water-based product, which is suitable for interior use on concrete walls and ceilings. Designed to fill surface imperfections in concrete block and poured concrete, to improve the appearance of the substrate. It can act as a finish or a primer for subsequent Dulux Trade finishes. Ideal where minimum downtime and efficiency is required. Caution: This product is designed only for the purpose of filling voids and pores within the surface of the concrete. Topcoats applied over excessive build-up of the Dulux Trade Blockfiller Plus can cause delamination of the filler, resulting in peeling of the topcoat.
|Coverage||Up to 5m² per litre|
|Touch dry||1 hour dependent upon temperature / humidity|
|Thinning||Do not thin this product.|
|Application||Brush, Roller, Conventional Spray, Airless Spray|
- One coat opacity saves time and money.
- Ideal where minimum downtime and a cost efficient system is required.
- Fills minor imperfections to act as a finish or primer for subsequent coats of paint.
To get the best results, make sure surfaces to be painted are clean, dry and free from all defective or poorly adhering material, dirt, grease and salts.
The preferred method of application is to apply a full, generous coat by airless spray followed immediately by tipping off with a medium pile roller. When applying by spray work the Blockfiller Plus into all pores and voids with the first pass then finish with a full coat of Dulux Trade Blockfiller Plus.
On concrete block and poured concrete, after surface preparation apply one coat of the Blockfiller Plus, which can be left un-topcoated or finished with an appropriate Dulux trade system matched to the substrate and environmental conditions.
After use remove as much paint as possible from the equipment before cleaning with clean water.