Avenue Anti-Graffiti Kit including remover
Our kits provide everything you need to create a graffiti resistance surface on wood, brick, masonry, metal or plaster. This kit contains, gloves, mixer paddle, mixing cup, brush and instructions as well as the 2pk** coating and a liquid aerosol from removing graffiti.
This kit come in 1L, 2.5L and 5L sizes depending on the area you are wanting to cover. One litre covers approximately 7 square metres. Being a water-based paint there is no need for solvents to clean up afterwards. Another advantage is water-based technology will not fade or yellow when exposed to high levels of ultra violet light or support the growth of fungus.
- For interior and exterior use.
- Low odour and fast drying.
- Can be used over compatible coloured paints.
- Dries to a hard, easy clean finish
- Suitable Surfaces: Wood, Brick, Masonry, Plaster
- Finish: Off Gloss
- Drying time: Touch Dry 1-2 hours or 24 hours hard dry
- Overcoat time: 18 hours
Please note the super hard-wearing coatings are for use on brick walls and fencing that hasnt been treated or painted. They can be used on a previously painted surface if a compatible water-based paint has been applied. This can be easily tested by applying the coating to a small area first*. Do not use over the top of solvent based paints.
*In many cases you will not know what type of paint has been used on the items you are proposing to protect. It may be water-based, solvent-based or even powder coated. Again, in these circumstances a small test area is the only method of ensuring best adhesion and gaining maximum properties of the anti-graffiti coating.
**A 2-pack product is made of two parts an A and a B. This requires mixing the two parts together so they can react to produce the final coating. The advantage of a 2-pack product is they are typically more durable. The disadvantage is you have to use them all up in one go unless you use a mixing cup to get the ratios right and just decant the right amount of each.
The liquid aerosol for removing graffiti just needs to be simply held upright 25 to 30 cm from the surface to be cleaned. Spray thoroughly and wipe clean with a soft, damp cloth or wash away with water. Tough on graffiti on a range of surfaces. It can also be used for the rapid and efficient removal of marks such as ink, crayon etc from hard, non-porous surfaces.